MasterForce 267-3333 Instrukcja Operatora Pobierz pdf (Strona 19)

LINE FEEDING

Your trimmer uses 0.065” diameter twist nylon line to cut grass and weeds

quickly and easily.

Check the nylon line regularly.

When trimming performance decreases, adjust the line length. With the

trimmer running, bump the cutting head on the grass; the nylon line will

extend automatically. Any excess will be automatically cut to length.

REPLACING SPOOL/ CLEARING JAMS AND TANGLED LINES

From time to time, especially when cutting thick , the line feeding hub may

become clogged with sap or other material and the line will become jammed

as a result. To clear the jam, follow the steps listed below.

1. Turn off the trimmer and remove the battery.

2. Press the release tabs on the

line spool cover, as shown in

Figure 13 and remove the cover

by pulling it straight off.

3. Lift the line spool out of the hub

and clear any broken line or

cutting debris from the spool

area.

4. In case of jams and tangled

line, unwrap about one foot

(30cm) of line to ensure that it is

undamaged. If it is OK rewind it

and insert the line end through

the eyelet in the spool hub, as

shown in Figure 14.

5. Press the spool down and

replace the spool cover,

ensuring that the release tabs

lock on both sides.

6. Reinstall the battery pack and

turn on the trimmer, adjusting

the line length to ensure that satisfactory cutting is maintained.

Fig. 13

Fig. 14

1 2 ... 14 15 16 17 18 19 20 21 22 23 24

Brak uwag

MasterForce 267-3333 Instrukcja Operatora Strona 19