MasterForce SM3051M Dokumentacja Pobierz pdf (Strona 12)

ESTIMATEDASSEMBLY TIME: 10~15

MINUTES

CAUTION

To avoid injury, do not connect this miter

saw to the power source until it is completely

assembled and adjusted, and you have read

and understood this Operator's Manual.

UNLOCKING THE SLIDE CARRIAGE (FIG. 1)

After removing the saw from the carton, loosen

the slide carriage lock handle (1). When

transporting or storing the miter saw, the slide

carriage should always be locked in position. The

slide carriage lock handle (1)is located on the

right side of the slide carriage.

Fig. 1

SWITCH HEAD (FIG. 2)

Raising

1. Push down slightly on the switch handle (1).

2. Pull out the hold-down latch (2).

3. Allow the switch head to rise to the up

position.

CAUTION

To avoid injury and damage to the saw,

transport or store the miter saw with the

switch head locked in the down position.

Never use the hold down latch to hold the

switch head in a down position for cutting

operations.

Fig. 2

Locking

When transporting or storing the miter saw, the

switch head should always be locked in the down

position.

1. Push the switch head down to its lowest

position.

2. Push the hold-down latch (2) into the locking

hole.

IMPORTANT: To avoid damage, never carry the

miter saw by the switch handle, the cutting arm

or the miter handle. ALWAYS use the designated

carrying handle located on the top of the

machine.

INSTALLING THE DUST BAG (FIG. 3)

1. Squeeze the metal collar wings (2) of the dust

bag (1).

2. Place the dust bag neck opening around the

exhaust port (3), and release the metal collar

wings.

Fig. 3

To empty the dust bag, squeeze the metal collar

and remove from exhaust port. Open zipper on

underside of bag and empty into waste container.

INSTALLING THE ARM BRACKETS FOR

EXTENSION WINGS (FIG. 4)

1. Place one flat washer (1) onto one lock knob (2),

insert through the arm bracket (3) and thread

into the extension wing. Repeat for second lock

knob.

2. Thread the extension wing lock knob (4) into

the threaded hole in the base (5) to lock the

extension wing into place.

3. Repeat steps 1 through 2 for left side extension

wing.

NOTE: The arm brackets serve two purposes: To

act as a stop block for repetitive cuts and to level

the workpiece when the extension wings are fully

extended for additional work support.

Fig. 4

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 37 38

Komentarze do niniejszej Instrukcji

Brak uwag

MasterForce SM3051M Dokumentacja Strona 12

Komentarze do niniejszej Instrukcji