MasterForce SM3051M Dokumentacja Pobierz pdf (Strona 19)

CAUTION

AVOID DIRECT EYE CONTACT

® Laser radiated when laser guide is turned

on, Avoid direct eye contact. Always un=

plug the miter saw from power source

before making any adjustments,

® Laser Warning Label: Max output <1roW

DIODE LASER: 630-670nm, Complies with

21CFR 1040.10 and 1040.11.

LASER RAOIA_FION

MAXOUtPUt_ ,mw OJO0__S_R _30670_m

_.50 CLASS *1LASER PROOUCT

® NOTE: All the adjustments for the operation

of this machine have been completed at the

factory.

® CAUTION-Use of controls or adjustments

or performance of procedures other

than those specified herein may result in

hazardous radiation exposure.

® CAUTION-The use of optical instruments

with this product will increase eye hazard.

® Do not attempt to repair or disassemble

the laser, if unqualified persons attempt

to repair this laser product, serious injury

may result. Any repair required on this

laser product should be performed by

authorized service center personnel.

SLiDiNG THE REAR EXTENSION SUPPORT

BAR (FIG. 24)

CAUTION

To avoid possible personal injury or damage

to the miter saw due to tipping, do not

operate the saw without the Rear Extension

Support Bar.

Loosen the two screws (1) and extend the rear

extension support bar (2) by sliding it out to

match position, tighten the two screws.

Fig. 24

)/

THE UPFRONT SUPPORTS ADJUSTMENT

(FIG. 45, 46)

Wide pieces need upfront supports (1).

1. Rotate the two upfront supports (1) toward

the rear of the saw.

Fig. 45

NOTE: These supports (1) should be

placed into the 0 position as shown in

Fig. 46 before transporting.

1

19

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 37 38

Komentarze do niniejszej Instrukcji

Brak uwag