MasterForce SM3051M Dokumentacja Pobierz pdf (Strona 18)

QUICK-CAM MITER TABLE LOCK

ADJUSTMENT (FIG. 21)

1. Press down and lock the miter quick-cam

table lock.

2. Using a 13 mm wrench, turn the stop nut (4) to

the left as shown to extend the locking arm

against the base of the miter saw.

3. Test the quick cam miter lock to verify it locks

the table into position securely.

4. Turn the lock nut (3) to the right as shown to

lock the miter locking mechanism into place.

Fig. 21

3 4

SETTING CUTTING DEPTH (FIG. 22)

The depth of cut can be preset for even and

repetitive shallow cuts.

1. Adjust the switch head down (See SWITCH

HEAD section) until the teeth of the blade are

at the desired depth.

2. While holding the upper arm in that position,

turn the stop knob (1) until it touches the stop

plate (2).

3. Recheck the blade depth by moving the

switch head front to back through the full

motion of a typical cut along the control arm.

Adjusting Cutting Depth (Fig. 22)

The maximum depth travel of the switch head

was set at the factory. Check to see that the

blade does not extend more than 1/4 in. below

the table insert, and does not touch the control

arm throat or any part of the base or table, if the

maximum depth needs readjusting:

1. Loosen the stop knob (1) while moving the

switch head down until the blade extends just

1/4 in. below the table insert.

2. Adjust the stop knob (1) to touch the stop

plate (2).

3. Recheck the blade depth by moving the

switch head front to back through the full

motion of a cut along the control arm. if the

blade touches the inside of the control arm,

readjust the setting.

Fig. 22

THE LASER GUIDE (FIG. 23)

1. To turn laser on, press on/off rocker switch (1)

to "ON" position.

2. To turn off laser, press on/off rocker switch to

"OFF" position.

Fig. 23

THE LASER BEAM

Your tool is equipped with the Laser guide using

Class II laser beam. The laser beam will enable

to preview the saw blade path on the stock to be

cut before starting the miter saw. This laser guide

is powered by the transformed alternating current

supply directly through the power lead. The saw

must be connected to the power source and the

laser on/off switch must be turned on for the laser

line to show.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 37 38

Komentarze do niniejszej Instrukcji

Brak uwag

MasterForce SM3051M Dokumentacja Strona 18

Komentarze do niniejszej Instrukcji